Write a comment

Pearl barley porridge in water in a multicooker

Satisfying and healthy pearl barley porridge in water in a multicooker is prepared without spending time and effort. In this case, the groats do not even need to be pre-soaked, as is usually done when cooking it on the stove. And the result exceeds all expectations: the porridge turns out tender, crumbly, and very tasty.

Yield: 4 servings.

Cooking time: 1.5 hours.

Caloric content: 86 kcal per 100 grams of the dish.

Ingredients

  • pearl barley – 300 g;
  • purified water – 800 ml;
  • salt – 1 tsp without a slide.

Preparation

1. Prepare the ingredients for making pearl barley porridge in water in a multicooker. In this example, a TEFAL multicooker is used, but the actions specified in the recipe should be performed sequentially in exactly the same way on devices from other manufacturers.

Ingredients for preparing barley porridge in water in a multicooker - photo step 1

2. Rinse the groats thoroughly several times until the water becomes clear.

Barley - photo step 2

3. Transfer the clean grains to the multicooker bowl and level them out.

Barley in a multicooker - photo step 3

4. Carefully pour in the water.

Barley in a multicooker with water - photo step 4

5. Immediately add salt and close the lid of the multicooker.

Preparing barley porridge in water in a multicooker - photo step 5

6. Set the program. Any product type can be selected - in this case, it does not matter, since the time will be programmed manually. Next, move the arrow to the "Stewing" process and set the cooking duration (that is - time) - 1 hour and 30 minutes. Press the start button.

Preparing barley porridge in water in a multicooker - photo step 6

7. These one and a half hours can be spent on other tasks - the multicooker will do all the work itself, it does not need to be monitored. At the end of the process, a signal will sound, after which you should press the "Reset program" button (that is, "Stop") and open the lid. If the multicooker is not turned off, it will automatically switch to the warming mode and will keep the porridge warm for another half hour, and then turn off by itself.

Barley porridge in water in a multicooker

8. The porridge turned out tender, and its grains are soft and easily separate from each other.

Barley porridge in water in a multicooker

Such pearl barley porridge in water in a multicooker is suitable for breakfast. You should only add a piece of butter and some vegetables for a richer taste. If a lean menu is being prepared, then instead of butter, the porridge can be dressed with vegetable sauté in vegetable oil. In both options, it is very delicious.

Barley porridge cooked in water in a multicooker

Write comments...
symbols left.
or post as a guest
Loading comment... The comment will be refreshed after 00:00.

Be the first to comment.